Factors affecting the production output of crushers

In the production process of the stone production line, the output will be affected by many factors

Pay attention to the following factors to improve the production capacity and performance of the crusher:

1. Correctly select the appropriate crushing cavity for the material to be crushed

2. The feed size ratio should be appropriate

3. Pay attention to control the feeding amount

4. The feed distribution needs to be evenly distributed within 360 degrees of the crushing cavity

5. The specifications of the discharge conveyor meet the needs of the maximum processing capacity of the crusher

6. Appropriate selection of vibrating screen specifications for pre-screening and closed-circuit screening

7. Set up automatic control device

8. The discharge area of the crusher is unobstructed.

The following factors will reduce the production capacity and performance of the crusher:

1. There are viscous materials in the feed of the crusher

2. The fine-grained materials smaller than the discharge opening in the feed exceed 10% of the crusher's production capacity

3. The moisture (moisture content) in the feed material is too large

4. Feeding segregation in the crushing cavity

5. Uneven distribution of feed along the periphery of the crushing cavity

6. Lack of feeding control device

7. The recommended motor power is not used

8. Insufficient conveying capacity of conveyor

9. The screening force of front screening and closed-circuit screening is insufficient

10. The discharge area of the crusher is not smooth enough

11. The crushed material is too hard or too tough

12. The drive shaft of the crusher runs at a speed slower than the recommended full load speed.

SANDMAN CRUSHER will provide you with quality service